Can you cut cellular blinds

Measure the blind from the end of the round pin to the flat pin on the opposite side. Use a pen to make a mark where you need to cut the roller. Pull out the staples with a staple remover, but only on the section you will no longer be using. It is unnecessary to take out the staples in the fabric you are still using.

Remove the metal cap and round pin from one end with a pair of pliers and pull straight off. Always cut the end with the round metal pin.

Put on your safety glasses. Take the shade and position one end so the blade of your chop saw lines up with the edge of the painter's tape. In one continuous motion and with steady pressure, carefully cut through the end of the shade. Repeat with the opposite end of the shade. By Michele M. Mark the desired length on the roller shade using a fine-tipped marker. Tape the roller shade using a small piece of tape. Insert the tip of the screwdriver under the bracket on the end which will be removed.

Once you've measured out the desired length of your shade cloth , cut it to size using heavy duty scissors, a utility knife, or our purpose-designed Coolaroo shade cloth cutter. Simply feed the shade cloth into the mouth of the cutter and pull it along your desired cut line while keeping the fabric taught. The roller blind can not be cut. Use a hacksaw to cut the metal roller away from the blinds.

Cut the metal at the mark you drew, using straightforward motions. Once you cut all the way through the metal, discard the excess roller and fabric. Hang the blinds in your window using mounting hardware. Inside-Mounted Horizontal Blinds Measure exact window width at top, middle, and bottom.

Use the narrowest width. Do not make any deductions - provide the exact measurements of the narrowest width. Measure exact window height at left, middle, and right side. Use longest height. When selecting window blinds , consider three measurements: window length, width and depth. Depth determines the size of slats, but standard window lengths are: 36 inches.

Standard window widths are: 24 inches. How to Hang Wood Blinds Without Brackets Drill two holes through the face of the head rail approximately 1 inch inward from each end. Place the head rail over the top window trim and center it over the window. Drill pilot holes into the top window trim with the drill and a drill bit approximately half the size of your screws.

Oversized cellular shades will make your windows look bulky and interior congested. Cutting them is the only way to adjust for the perfect fit.

But if you are a DIY enthusiast and wish to do it by yourself in order to save a little, then this is not a complicated project to do.

Here is a quick summary of the steps to take to get you started:. Following the below steps ensure an easy and efficient cutting of cellular shades that will perfectly fit windows without any hassles, giving windows maximum coverage while offering all the benefits. Consult with the experts to avoid errors if you are unsure. ZebraBlinds is not responsible for any damages caused through DIY methods.